Removing The Level Sensor From The Mounting Plate; Assembling The Level Sensor On The Mounting Part - Baxi CBP Matic 18 Manual

5 – The level sensor must be assembled on the right side of the storage unit (on the
closest side to the boiler). For this, you must change the position of the sensor in the
mounting plate in which it is fixed:
- remove the level sensor of the mounting plate, by removing the 4
screws that secure it;
Figure 43 – Removing the level sensor from the mounting plate
- To assemble the sensor on the opposite side of the mounting plate you should
mount it as shown in the following figure:
Figure 44 – Assembling the level sensor on the mounting part
- Finally, you can mount the two mounting plates at the bottom of the storage unit,
putting the plate with the level sensor on the right side and the plate without level
sensor on the left side. The level sensor must be assembled as shown in Figura 45-c.
a)
a)
b)
b)
59