Installing The Autotrace Software - Thermo Scientific Dionex AutoTrace 280 Operator's Manual

Dionex AutoTrace 280 Operator's Manual
Switching Valves
Figure B-15. Dionex AutoTrace 280 Left-Side View
2. Make sure each compression fitting is finger-tight. Tip: If necessary,
you can remove any switching valve from the left-side panel to
improve access to the valve fittings.
3. Perform the same check for the compression fittings on the pumps
and the cartridge or disk holders on the front of the system.
B.3.6

Installing the AutoTrace Software

Always install the AutoTrace software before connecting the USB cable
or turning on the power to the Dionex AutoTrace 280 and the PC. This
ensures that the USB driver for the Dionex AutoTrace 280 is
automatically loaded and the Microsoft Windows operating system can
detect the system when the power is turned on.
1. For a local PC: Log onto Windows as an administrator.
For a network PC: Log on as a user with local PC administrator
privileges.
2. Insert the AutoTrace software CD (P/N 072581) into the CD drive.
140
Compression Fitting
Air Push Valve
Doc. 065330-05 03/2020