B • Installation; Facility Requirements; Unpacking The Dionex Autotrace 280 - Thermo Scientific Dionex AutoTrace 280 Operator's Manual

B.1 Facility Requirements
•
Check that the installation site meets the power and environmental
specifications listed in
•
Provide a level, stable, and flat surface with enough room to accommodate the
Dionex AutoTrace 280. The system is 69 cm (27 in) high x 57 cm (23 in) wide
x 63.5 cm (25 in) deep.
•
Check that there is an additional 1 square meter (2 to 3 sq. ft.) of space on the
left side of the Dionex AutoTrace 280 for the solvent reservoirs.
•
If the 6-position sample rack (P/N 071333) will be installed, check that there
is enough room on the right side of the Dionex AutoTrace 280. The sample
rack is 42.16 cm (16.6 in) x 33.02 cm (13.0 in).
B.2 Unpacking the Dionex AutoTrace 280
Lift the Dionex AutoTrace 280 only from the bottom and/or sides of the
instrument. Use caution when lifting the Dionex AutoTrace 280: it
weighs 43.09 kg (95 lb).
Ne soulevez le Dionex AutoTrace 280 que par le fond ou les côtés.
Soyez prudent lorsque vous soulevez le Dionex AutoTrace 280: il pèse
43.09 kg.
Wenn Sie den Dionex AutoTrace 280 anheben oder bewegen möchten,
greifen Sie bitte unter den Boden oder heben Sie das Gerät an den
Seiten an. Seien Sie vorsichtig, wenn Sie den Dionex AutoTrace 280
anheben. Das Gerät wiegt 43.09 kg.
1. Open the Dionex AutoTrace 280 shipping container. Remove the Dionex
AutoTrace 280 and place it on the workbench.
2. Unpack the Ship Kit (standard Dionex AutoTrace 280, P/N 071383; Dionex
AutoTrace 280 PFAS, P/N 22136-62005) and all other items included in the
Doc. 065330-05 03/2020
Appendix A.
B • Installation
127