Adjusting The Log Length - Hakki Pilke Raven 33 Manual

4.2

ADJUSTING THE LOG LENGTH

The Hakki Pilke Raven 33 firewood processor is equipped with a mechanical log measuring device with an incre-
mented adjustment value of 25 to 50 cm.
1. Turn off the machine, disconnect it from any power source, and open the protective cover of
the machine.
2. Set the wood limiter in the splitting section to the desired length by removing cotter pin B
from the limiter's locking pin and pulling out locking pin A (Figure 19). Lock limiter plate C
(Figure 19) in the desired position. Re-insert locking pin A and cotter pin B.
3. Do not keep the limiter plate in the position shown in Figure 20 when processing logs over 20
cm in diameter. Otherwise the oversized log may damage the plate during splitting. The posi-
tion shown in Figure 20 is intended for thin and curved logs which may otherwise pass under
the limiter plate, failing to stop at the correct measurement.
Note! Turn the limiter plate to the correct position according to the thickness of the log. (See
Figures 19 and 20).
Figure 19. Limiter plate position for large logs of more than 20 cm in diameter
HAKKI PILKE RAVEN 33
25
TRANSLATION VERSION 1