Table of Contents
Advertisement
5. Remove the old belt.
6. Insert the new belt from the side of
the in-feed conveyor's drive roller
through opening B (Figure 32), until
you can pull the belt out from other
end C (Figure 33). Note! If necessary,
remove the guard of the in-feed con-
veyor in accordance with the instruc-
tions in Section 4.5.
7. Lead the rest of the belt under the log
press, around the rear roller and, final-
ly, behind the conveyor.
8. Connect the joint by inserting pin A
(Figure 31) into the joint.
9. Turn the conveyor back to the operat-
ing position and tighten the belt. Use
adjustment nuts D (Figure 34) to adjust
the belt.
The belt is at the correct tension when
its middle section is raised approx. 5 cm
when the conveyor is in the operating
position. An excessively tight belt may
be damaged more easily, and it places
unnecessary strain on the conveyor
bearings.
HAKKI PILKE RAVEN 33
32
Figure 32.
Figure 33.
Figure 34.
TRANSLATION
VERSION 1
Advertisement
Table of Contents
