Hakki Pilke Raven 33 Manual page 10

Place the in-feed conveyor in the operating position as follows:
1. Ensure that sufficient room is available to lower the in-feed conveyor (approx. 2 m).
2. Remove the other end of the support leg holder C from the lug (Figure 2).
3. Release the lock by removing pin A and turning locking latch B out of its slot (Figure 3).
Note! At the same time, hold the end of the in-feed conveyor with your left hand!
4. Lower the in-feed conveyor with your left hand while simultaneously using your right hand to guide support leg
D into slot E (Figure 4).
When placing the in-feed conveyor in the transport position, lift the conveyor to the upper position, turn
locking latch B into its slot and insert pin A (Figure 3). Use holder C to lock the support leg in place (Figure
2).
HAKKI PILKE RAVEN 33
10
Figure 4.
TRANSLATION VERSION 1