Hakki Pilke Raven 33 Manual page 12

10. Use a winch to lift the conveyor to
the desired angle (max 40°) and lock
the upper section of the out-feed
conveyor to the operating position
using lock D (Figure 8).
Place the out-feed conveyor in the transport position as follows:
1. Turn off the machine.
2. Release lock D (Figure 8) and lower the conveyor to the lowest possible position with the winch.
3. Turn support bar C (Figure 7) to a position over the belt, and turn the upper section of the con-
veyor onto the lower section using handle B (Figure 6).
4. Turn the conveyor to the middle position (only in machines with a pivoting conveyor). See Sec-
tion 3.6.
5. Lift the conveyor with the winch until it locks into the raised position. Ensure that lock A (Figure
5) settles properly into place.
Note! Do not stand on the out-feed conveyor! Do not use the winch if the belt is worn!
HAKKI PILKE RAVEN 33
12
TRANSLATION
Figure 8.
VERSION 1