Hakki Pilke Raven 33 Manual page 28

Replacing the saw bar
Replace the saw bar as follows:
1. Remove the saw chain according to steps 1-5 of Section 4.6 "Replacing and tightening the saw chain".
2. Remove the saw bar bolts (2 pcs) and remove fastening plate A (Figure 27).
3. Remove the saw bar from the groove.
4. Place the new bar against gear wheel B (Figure 27), twist it into the groove and loosely attach the saw
bar bolts and fastening plate A.
5. Attach and tighten the saw chain according to steps 6-8 in Section 4.6 "Replacing and tightening the saw
chain".
HAKKI PILKE RAVEN 33
28
Figure 24.
TRANSLATION VERSION 1