Part 3 - Electrical Installation / Connections; Vav Zone Controller - Prolon VC2000 Installation And Startup Manual

Part 3 - Electrical Installation / Connections

VAV Zone Controller

Inputs
• Wall Sensor (PL-T200/T500/T1000): 4 wire cable (#22/4
shielded cable recommended) connected to terminals
#9 to #12.
• Changeover Sensor (if required): directly to terminals
#13 & #14.
o Digital output (24Vac or dry contact): For dry contact, connect
Digital Output (24VAC or dry contact): For dry contact, connect to terminals #5
to terminals #5 and #6 (no jumper between #4 and #5). For
and #6 (no jumper between #4 and #5). For 24VAC output, connect to terminals
24Vac output, connect to terminals #3 and #6 (jumper installed
#3 and #6 (jumper installed between terminals #4 and #5).
between terminals #4 and #5)
REV 7.0.0 / PL-TRA-STARTUP-EN
Supply
• 5VA per zone / max 100VA per circuit.
• Link the #1 & #2 terminals in a daisy chain.
• Respect the live / common polarity on all controllers.
• Ground the common (at central transformer).
• Ground all controllers' commons. (if using multiple
transformers).
Part 3 : Electrical Installation / Connections
• Analog Output (0-10VDC): connect to terminals #7(-)
and #8(+). Respect the polarities.
Input/Outpout wiring for a
VC-2000
VAV Zone Controller
Network cabling
Inputs
o Wall sensor (PL-T
#18/2 + #24/2 (su
–or- LVT 4-conduc
to terminals #9 to
shielded cable pre
o Changeover sens
directly to termina
Supply
o 5VA per zone / ma
o Link the #1 & 2 te
Respect the live /
controllers
o Ground the comm
transformer)
o Metallic ground al
commons. (multip
o Analog output (0
terminals #7(-) an
polarities.
5 5