Raven RS1 Calibration & Operation Manual page 22

Hide thumbs Also See for RS1:

Table of Contents

HAPTER

FIGURE 24. Antenna Fore/Aft Screen

4. Select the value box to enter the Antenna Fore/Aft position.

NOTE:

The Antenna Fore/Aft position is calculated by measuring from the rear axle of the machine to the

middle of the RS1 unit. A negative value should be entered if the RS1 unit is located behind the rear

axle.

5. Select the Next arrow.

FIGURE 25. Antenna Center Offset Screen

6. Select the value box to enter the Antenna Center Offset position.

NOTE:

The Antenna Center Offset position is calculated by measuring from the center of the machine to the

center of the RS1 unit. A negative value should be entered if the RS1 unit is located to the left of the

machine's center line.

7. Select the Next arrow.

Raven RS1™ Guidance and Steering Calibration & Operation Manual

Table of Contents