Raven RS1 Calibration & Operation Manual page 15

Hide thumbs Also See for RS1:

Table of Contents

FIGURE 8. Antenna Height Screen

7. Select the value box to enter the Antenna Height.

NOTE:

The Antenna Height is calculated by measuring from the ground to the center of the RS1 unit.

8. Select the Next arrow.

FIGURE 9. Wheel Base Screen

9. Select the value box to enter the Wheel Base.

NOTE:

The Wheel Base is calculated by measuring from the center of the front tire to the center of the rear

tire on both sides of the machine. Add these measurements together and then divide by 2 to get the

average Wheel Base value.

10. Select the Next arrow.

P/N 016-4010-001 Rev. A

CALIBRATION

Table of Contents