Table of Contents
Advertisement
INX***DH-F199-IE2-***, INY***DH-F199-IE2-***
Product Description
2
Product Description
2.1
Use and Application
INX***DH-F199-IE2-*** and INY***DH-F199-IE2-*** series inclination sensors detect and
measure the tilt angle (inclination/slope/elevation) of an object in relation to the force of gravity.
The basic principle behind these inclination sensors is a microelectromechanical systems
(MEMS) sensor cell that is embedded in a fully molded application-specific integrated circuit
(ASIC). The angle is measured by the relative change in electrical capacitance in the MEMS
cell.
INX***DH-F199-IE2-*** sensors are 1-axis sensors that detect and measure the tilt around the
x-axis.
INY***DH-F199-IE2-*** sensors are 2-axis sensors that detect and measure the tilt around the
x-axis and the y-axis.
Communication with the inclination sensors for data output occurs via an analog current
interface from 4...20 mA.
Communication with the inclination sensors for programming occurs via RS232 interface
and/or anlaog inputs.
2.2
Connection Cable for Normal Operation
To use the inclination sensor for normal operation in the plant, select one of the following
connection cables. Additional connection cables are available as accessories.
Connection type on
the inclination sensor Connection cable
M12, 8-pin, A-coded
M12, 8-pin, A-coded
Table 2.1
8
V19-G-2M-PUR-ABG-V19-G
V19-G-2M-PUR-ABG
Connection type of the adapter cable
Inclination sensor side: M12 single-
ended female cordset, 8-pin
Other side: M12 single-ended male
cordset, 8-pin
Inclination sensor side: M12 single-
ended female cordset, 8-pin
Other side: 2 m cable with free
cable end
Advertisement
Table of Contents
