Measurement Direction; Set Maximum; Reset Maximum; Restore Factory Settings - Pepperl+Fuchs INX DH-F199-IE2 Series Manual

INX***DH-F199-IE2-***, INY***DH-F199-IE2-***
RS232 Interface Setup and Programming
5.3.8

Measurement Direction

Function Description
Measurement Inverts measurement
Direction direction.
Note: Before using
the command, ensure
that the sensor is set
to "teach 0".
Table 5.10
5.3.9

Set Maximum

Function Description
Set maximum The current angle
at current position is set to the
position maximum analog
output value.
Note: Before using
the command, ensure
that the sensor is set
to "teach 0".
Table 5.11
5.3.10

Reset Maximum

Function Description
Reset The execution of this
maximum to function clears the
factory settings previous scaling of
maximum set by the
user and resets the
analog output to the
factory default values.
Before using this
command, ensure
sensor is set into
"teach 1"
Table 5.12
5.3.11

Restore Factory Settings

Function Description
Restore factory Restore factory
settings settings
Table 5.13
5.3.12

Save Settings to EEPROM

Function Description
Save Settings All settings that are
to EEPROM modified will be
saved in the
EEPROM
Table 5.14
Command
compl<SP>parameter<CR>
Command Explanation
setmax<CR> The command execution
immediately sets the analog
output to 20 mA.
The maximum angle set in this
mode will not affect the RS-232
position output. This scaling only
affects the analog output.
Command Explanation
clrmax<CR> The command execution
immediately sets the analog
output to 20 mA.
Command Explanation
restore<CR>
–
Command Explanation
save<CR> In case of changing the baud
rate, the new baud rate will be
active directly after a <CR>, a
"save" command is not required.
Parameters
0 = clockwise only
1 = counterclockwise
= SET 2 acitvate
(change only via anlog
inputs: L = clockwise,
H = counterclockwise)
Default
0
Default
–
Default
–
Default
–
Default
–
23