Table of Contents
Advertisement
CCS50D
Fitting the protection cap on the sensor
1.
To keep the membrane moist after the sensor has been removed, fill the protection cap
with some electrolyte or clean water.
17
Carefully slide protection cap onto the membrane cap.
2.
Top part of protection cap is in the open position.
Carefully slide protection cap onto the membrane cap.
3.
Secure protection cap by rotating the top part of the protection cap.
18
Securing protection cap by rotating the top part
9.2.5
Regenerating the sensor
During measurement, the electrolyte in the sensor is gradually exhausted due to chemical
reactions. The gray-brown silver chloride layer that is applied to the anode at the factory
continues to grow during sensor operation. However, this has no effect on the reaction taking
place at the cathode.
Endress+Hauser
Maintenance
A0034264
A0034494
37
Advertisement
Table of Contents
Need help?
Do you have a question about the CCS50D and is the answer not in the manual?
Questions and answers