Arming The System; Using A Pin Code Or Proximity Tag; Using The Wireless Keyfob; Disarming The System - Pyronix ENFORCER V11 Extended User Manual

Enter a valid PIN code or present a valid tag to the symbol as
shown.
Enter the area you wish to arm and press f. 'Please wait
setting wireless' will be displayed.
There are three different arming methods your installer will
instruct you through:
Final Door: Leave the building and make sure the exit door is
closed properly.
Timed: Make sure you leave the building before the timer shown
on the keypad expires.
Push to set: Press the push to set button installed by your
engineer to arm the system.
To arm via a keyfob. Pressand hold for less than 2 seconds.
The keyfob LED will start to flash green indicating that the system is
starting to arm.
'Please wait setting wireless' will be displayed on the keypad and the
programmed area will begin to arm.
To 'quick arm' , press and hold thekey again for four seconds.
Once armed, the keyfob LED will illuminate RED indicating that the
system is now armed.
Enter the building, the 'entry time' will start.
Enter a valid PIN code or present a valid tag to the symbol as
shown.
The area that the code is assigned to will be disarmed.
Please note: If 'flexi-set' is disabled then the system will automatically disarm the area armed once a valid
user code or tag is presented.
ENFORCER V11 EXTENDED USER GUIDE

ARMING THE SYSTEM

USING A PIN CODE OR PROXIMITY TAG

Enter Your Code
Set Areas?
Please leave via
Exit Route

USING THE WIRELESS KEYFOB

<2 seconds

DISARMING THE SYSTEM

USING A PIN CODE OR PROXIMITY TAG
ENTRY TIME
Enter Your Code
Alarm Panel
Time
[******]
[A ]
[30]
[******]
10:09 c
9