Electrical Connection; Operation; Display And Control; Main Menu - Grundfos Selcoperm SES 125-2000 Installation And Operating Instructions Manual

4.3 Electrical connection

Warning
Before making any electrical connections, switch off
the power supply and make sure that it cannot be
accidentally switched on.
All electrical connections must be carried out by a
qualified electrician in accordance with local
regulations.
All electrical connections must be carried out in
accordance with the separate wiring diagram
delivered with the system.
See also section 3.11.1 Field wiring

5. Operation

5.1 Display and control

Most functions can be controlled at the display and control
elements (see fig. 2, pos. 28). During operation, the process can
be manually stopped or remotely stopped through external
contact.
The display shows the following information:
• System status
• System information
The system reverts back to main display screen
Note automatically when the tank is full or when a fault
occurs.
SYSTEM OK
GENERATING
TANK LEVEL xx %
DEL
OK
ESC
Fig. 11 Control and display with main display screen
Key Function
DEL Key is not assigned
STAR Key is not assigned
ALT Service menu 1
Enter Service menu 1.
ESC Escape
Escape takes you back to main display screen.
OK Restart
Press OK to restart system after a fault has
occurred.
UP
Screen selection
DOWN
LEFT Manual stop in main display screen:
Can be used to stop the electrochlorinator.
Pressing once more will restart the
electrochlorinator.
RIGHT Select and adjust values in service menu 1.
16
diagram.
ALT
*

5.2 Main menu

The main menu can be accessed without entering a password.
It contains four screens with following information:
Main display screen with system status and "TANK
1
LEVEL" in percent
2 "AMPS" (amperage) and "VOLTS" (voltage)
"AIR FLOW" and "GENERATING TIME" (operating hours)
3
4 Contact details Grundfos
Scroll through the screens using the [UP] and [DOWN] keys.
Press [ESC] to return to main display screen.
5.3 Service menu 1
The service menu 1 allows the operator to adjust the
electrochlorinator's running parameters.
To enter service menu 1, a password (code) is required.
5.3.1 Enter service menu 1
1. Press [ALT] in main menu screen 4.
2. Enter the password "01987" with the scroll keys.
3. Press [OK]. First screen of service menu 1 will be displayed.
– Scroll through the screens using the [UP] and [DOWN] keys.
– Press [OK] to edit a set point.
– Use the scroll keys to set new values.
– Press [ESC] to exit the edit mode.
– Once all values are set, press [ESC] to exit service menu 1
and return to main display screen in main menu.