Electrical Connection; Startup; Control Panel - Grundfos Hydro Solo-E Safety Instructions And Other Important Information

4. Electrical connection

Carry out the electrical connection according to local
regulations.
Check that the supply voltage and frequency
correspond to the values stated on the nameplate.
Warning
Before making connections in the terminal
box or breaker cabinet, make sure that the
power supply has been switched off for at
least 5 minutes. Make sure that the power
supply cannot be accidentally switched on.
The product must be connected to an
external all-pole mains switch according to
local regulations.
The product must be earthed and
protected against indirect contact in
accordance with local regulations.
We recommend to fit the permanent
installation with an earth leakage circuit
breaker (ELCB) with a tripping current < 30
mA.
If the power supply cable is damaged, it
must be replaced by the manufacturer, the
manufacturer's service partner or a
similarly qualified person.

5. Startup

Do not start the pump until it has been
Caution
filled with liquid.
6

6. Control panel

Warning
The product may be so hot that only the
buttons should be touched to avoid burns.
Fig. 1 Standard control panel
Pos. Symbol Description
Grundfos Eye
Shows the operating status of
1 the pump.
See section
product
Light fields for indication of
2 -
setpoint.
3 Changes the setpoint.
Enables radio communication
with the Grundfos GO Remote
4
and other products of the
same type.
Makes the pump ready for
operation/starts and stops the
pump.
Start:
If the button is pressed when
the pump is stopped, the
pump will only start if no other
functions with higher priority
have been enabled.
5 See section
product
Stop:
If the button is pressed when
the pump is running, the
pump will always be stopped.
When the pump is stopped via
this button, the "Stop" text
next to the button will
illuminate.
1
2
3
4
Stop
5
10. Further
information.
10. Further
information.