Timer Operations; 7-Day Timing Operations - Hisense AHM-080FJFAA Operation Installation Maintenance Manual

● After the keyboard of wire controller is locked, it
will give no response to key acting and prevent
wrong operation by children.
● Keyboard lock does not affect the run state of the
machine.

5.1.5 Timer Operations

● At the timed running state, system will run or stop
at the set time.
● When the timing function is set, the timer setting
after instantaneous power failure will maintain;
after long-time power off, the timing function will
be automatically cancelled.
5.1.5.1 Set Floor Heating Timer
Step 1
Power on, four straight lines will appear on the
display screen. The function run previously may also
appear.
Step 2
Press the function selection key ⑥, and the floor
heating icon appears on the LCD screen.
Step 3
Press " " of the temperature control key ③ to
increase the water outlet set temperature; press
" " to reduce it. For floor heating, the highest
water outlet set temperature is 55°C and the lowest
set temperature is 20°C.
Step 4
If press the timing key ⑩ at the stop state, the
indications " " and "
press the timing key ⑩ at the run state, the
indications " " and "
" will appear. If
" will appear.
Press " " of the time setting key
will increase; press " " key, the set time will
decrease. The set time may be between 30 minutes
to 24 hours and adjusted at the interval of 30
minutes. At the timed run state, system will run or
stop after the set time.
For example, if the set time is "09：30 ", the
machine will run or stop 9.5 hours later.
5.1.5.2 Set Domestic Hot Water Timer
The domestic hot water timer has the same setting
as the floor heating timer. Select the domestic hot
water function, and operate as per Step 4 of 5.1.5.1.
5.1.5.3 Cancel Timing
Press the timing key ⑩ again, the timer indication
disappears and the timing function is cancelled.

5.1.6 7-Day Timing Operations

5.1.6.1 Entry and Exit from 7-day Timing Mode
Press the time schedule key ⑨ to go to and quit from
7-day timed run mode. At the 7-day timed run mode,
the machine starts and stops as scheduled procedures.
At this mode, it is able to manually start/stop, adjust
water temperature, change the running function and
start the timer. If instantaneous power failure or long-
time power off occurs at 7-day timed run mode, after
reenergizing, it still runs as per the requirement for 7-
day timing. If two settings appear at the same time
point, the later setting will prevail. During 7-day
timing setting, the
ON/OFF
necessarily occur in pairs.
After long-time power off, reenergizing needs to
check whether the data and time are correct. If
the time needs to be adjusted, refer to 5.1.1
standard time setting.
14
Action Time
Timer Indication
, the set time
Timer Indication
time points are not