Page 4
Manufacturing number and manufacturing year: refer to model Nameplate. Notes: This declaration becomes invalid, if technical or operational modifications are introduced without the manufacturers consent. Hisense Italia S.r.l. is authorised to Compile the Technical Construction File. Ad. : Via Montefeltro 6A, 20156 Milano. Name, Surname Position/ Title...
Page 9
Wall-Mounted Type The appliance is not to be used by children or person with reduced physical, mental capabilities,or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised that they do not play with the appliance.
Page 11
Press switches only with fingers. Do not press switches by any other item,as it may break switches. " " " " , 2014- 08 - 18 Fri...
Page 16
Users can not change power lines by themselves, replaced by professional maintenance staffs. 2. Necessary Tools and Instrument List for Installation irrelevant...
Page 18
Fig.4.3 Mounting Bracket Model 07 17 18 24...
Page 20
Any gap will lead to leak or frost. When removing f panel, do not apply strong forces by hitting, etc. It may break the unit body. R410A Model 12.7(1/2) 6.35(1/4) 07 17 15.88(5/8) 9.53(3/8) 18 24...
Page 21
When bending the pipes, firmly fix the pipe at the heat exchanger side. 07~17 18~24 404 20R 07~17 355 25R 18~24...
Page 22
Stopper Torque(N.m) Pipe Diameter 6.35 Plate for Pipe 9.53 12.7 15.88 Drain Piping Contour of the Unit 65 Hole for Rear Side Connection for Wiring and Piping 07~17 18~24 An excess or a shortage of refrigerant is the main cause of trouble to the units.
Page 23
Tighten screws according to the following torque. Do not connect the drain pipes with M3.5: 1.2 N m sanitary or sewage or any other 2.0 to 2.4 N m drainage pipe. When installing the pipe, do not tie the drain pipe and refrigerant pipe together. Pay attention to the thickness of the insulation when the left side piping is performed.
Page 24
Ⅰ Cord Clamp Wires through the space Cord Clamp...
Indoor Unit Model 07~24 For Control Circuit Fuse Capacity Freeze Protection Cut-Out Thermostat Cut-In Thermostat Differential...
Page 26
10.1 Field Minimum Wire Sizes for Power Souce The wire sizes marked with *1 in the above table are selected at the maximum current of the unit according to the European Standard, EN60335-1.Use the wires which are not lighter than the ordinary polyvinyl chloride sheathed flexible cord (code designation H05VV-F).
Page 28
10.3 Setting the Filter Indication Interval The FILTER indication interval on the remote control switch can be set approximately 100, 1,200 or 2,500 hours (factory setting: 200 hours). If 100, 1,200 or 2,500 hours interval is required, follow the instructions below. FILTER Indication Interval Approx.