Hisense AHM-080FJFAA Operation Installation Maintenance Manual page 15

5.1.3.2 Floor Drying
Step 1
At the standby state, press simultaneously the
reset key ⑤ and the hot water key ② for 3
seconds, go to floor drying.
Test Run
flashes at 1 Hz
Step 2
Heating for 7 days at this mode, and the
water outlet temperature automatically follow
the requirements.
T
● Water outlet temperature is set as 25°C
running for 72 hours
● Water outlet temperature is set as 35°C
running for 48 hours
● Water outlet temperature is set as 40°C
running for 48 hours
Step 3
After the floor drying runs for 7 days, the water
outlet temperature of water module returns to the
set value. If there isn't a set value, it returns to
the default value.
● ● Before each heating season, user must run the
floor heating to prevent damage to the floor
from the very quick temperature rise.
● Water must be replenished in the water system ● Water must be replenished in the water system
(reconfirm that the vent valve is open) before (reconfirm that the vent valve is open) before
floor heating, and confirm that the water floor heating, and confirm that the water
pressure is within a normal range. pressure is within a normal range.
● ●
At the floor drying mode, the wire controller only
responds to the startup/shutdown requests, but
not to other modes, functions and temperature
adjustment, etc.
● 7 days are the accumulated time for floor drying. ● 7 days are the accumulated time for floor drying.
If the machine is shutdown halfway, after startup If the machine is shutdown halfway, after startup
next time, it will continue the floor drying. The next time, it will continue the floor drying. The
run icon flashes at 1 Hz. run icon flashes at 1 Hz.
● If instantaneous power failure occurs while ● If instantaneous power failure occurs while
running, it continues floor drying after power running, it continues floor drying after power
connection. In case of power on after long-time connection. In case of power on after long-time
power off, it goes to the off state of floor drying. power off, it goes to the off state of floor drying.
Press the Press the
drying again (running time accumulates for 7 drying again (running time accumulates for 7
days). days).
Press simultaneously the reset key ⑤ and the hot
Day
water key ② for 3 seconds, quit from the floor
drying in advance. Be careful, quitting from the
floor drying in advance may cause damage to the
user's floor.
9
key key ⑧, go to the floor ⑧, go to the floor
ON/OFF ON/OFF