Mode Settings; Temperature Settings; Fan Speeds; Timer, Sleep, Filter Functions - Hisense AW0823TW1W Use And Installation Manual

Operation (continued)

MODE SETTINGS

□ Press MODE repeatedly until you see the indicator light glow for the desired setting.
□ Choose Fan, Dry, Cool, Eco.
□ FAN - To select Fan Only mode.
□ Dry - Dries the room. The air conditioner automatically selects the temperature. Fan runs at Low speed
only.
□ Cool - Cools the room.
□ Eco - Cools the room and saves energy.
NOTE: Dry mode should not be used to cool the room.
□ For E-star models, the fan will continue to run after the compressor shuts off for 2 minutes (4 minutes
for the first time), then the fan will shuts off for 10 minutes.The fan then cycles for intervals of 2
minutes on and 10 minutes off until the room temperature is above the set temperature, at which time
the compressor turns back on and Cooling resumes. Select ECO mode to initiate this function.

TEMPERATURE SETTINGS

□ Press the plus UP
button, the temperature will go up 1 °F (1 °C) until it reaches 86°F (30°C).
□ Press the minus DOWN
DOWN button, the temperature will go down 1 °F (1 °C) until it reaches 61 °F (16°C).
□ To change the temperature display from °F to °C: Press both the MODE and DOWN
the same time for 5 seconds to switch the display from °F to °C.

FAN SPEEDS

NOTE: The Fan button will operate only when the Fan, Cool, ECO or Heat mode has been
selected.
□ Press FAN until you see the indicator light glow for the desired setting.
□ Choose High, Med, Low.
□ High - for maximum cooling
□ Med - for normal cooling
□ Low - for quieter cooling
NOTE: In ECO mode,the Fan will run at low speed when compressor turns off.

TIMER, SLEEP, FILTER FUNCTIONS

□ The LED light on control panel for Timer, Sleep, Filter.
□ For function operation, see "Using the Remote Control."
button to raise the temperature. Each time you press or hold the plus UP
button to lower the temperature. Each time you press or hold the
15
buttons at