Download Print this page
Hisense AVE-07UX2SAL Operation Installation Maintenance Manual
Hisense AVE-07UX2SAL Operation Installation Maintenance Manual

Hisense AVE-07UX2SAL Operation Installation Maintenance Manual

Inverter driven multi split

Advertisement

Quick Links

说明书归档首页
说明书编
P00546Q
号:
□ 全新编制
□ 衍生机型
编制说明
(首版编
制时请填
□ 临时对应
写)
签字区
设计:
审核:
标准化:
批准
标记
×6
变更履历
×
×2
(变更说
明书时请
×2
填写)
×
×
×
变更内容简要描述
说明书增加二维码的设计变更
表格信息变更
本次变更
内容简述
担当联络方式
邮箱
适用产品序列:
适用机型系列:
衍生产品序列: 海信出口薄型天埋 L/M 系列(60HZ)
衍生机型系列: AVE-07~14UX2SAL
源产品序列:
源机型系列:
源说明书编号:
对应简要说明:
源说明书编号:
签名
郭来红
邓玉平
霍艳萍
前田宪作
管理编号:
日期:
BZ/KF1507-021 15.07.08 王洪新
BZ/KF1507-021 15.11.22
BZ/SJ-1803-005 18.03.23 冯月文
版本号: V03
AVE-17~24UX2SBL
版本号:
日期
13.03.25
13.03.27
13.03.27
13.03.27
更改:
审核:
邓玉平
陶友淘
涉及页码
封底
P14
80879914 冯月文
fengyuewen@hisensehitachi.co
m
批准:
前田宪作
邓玉平

Advertisement

loading
Need help?

Need help?

Do you have a question about the AVE-07UX2SAL and is the answer not in the manual?

Questions and answers

Summary of Contents for Hisense AVE-07UX2SAL

  • Page 1 说明书归档首页 说明书编 版本号: V03 P00546Q 号: 适用产品序列: □ 全新编制 适用机型系列: 衍生产品序列: 海信出口薄型天埋 L/M 系列(60HZ) 衍生机型系列: AVE-07~14UX2SAL AVE-17~24UX2SBL □ 衍生机型 源产品序列: 源机型系列: 编制说明 源说明书编号: (首版编 制时请填 对应简要说明: □ 临时对应 写) 源说明书编号: 版本号: 签字区 签名 日期 设计: 郭来红 13.03.25 审核: 邓玉平 13.03.27 标准化:...
  • Page 2 INVERTER-DRIVEN MULTI-SPLIT AIR-CONDITIONER (HEAT PUMP) LOW-HEIGHT AVE-07UX2SAL,AVE-09UX2SAL AVE-12UX2SAL,AVE-14UX2SAL CEILING AVE-17UX2SBL,AVE-18UX2SBL DUCTED AVE-22UX2SBL,AVE-24UX2SBL TYPE P 0 0 5 4 6 Q ORIGINAL INSTRUCTIONS...
  • Page 4: Important Notice

    To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling. Hisense's Hisense's...
  • Page 5 Section2 Installation & Maintenance Manual...
  • Page 6 The appliance is not to be used by children or person with reduced physical, sensory or mental capabilities,or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised that they do not play with the appliance.
  • Page 7 3.Unit Drawing & Function Key Definition Model 07~14 Model 17~24 Part Name Part Name Refrigerant Liquid Pipe Connection Fan Motor Float Switch Heat Exchanger Drain Pan Distributor Air Outlet Air Inlet Strainer Micro-Computer Control Expansion Valve Drain Discharge Mechanism Electrical Control Box Shift Joint 17 24 Refrigerant Gas Pipe Connection...
  • Page 8: Before Operation

    4. Before Operation Supply electrical power to the system for approximately 12 hours before start-up after long shutdown. Do not start the system immediately after power supply, it may cause a compressor failure,  because the compressor is not heated well. Make sure that the outdoor unit is not coverd with sonw or ice If covered, remove it by using hot water (less than 50℃). If the water temperature is higher  than 50℃, it will cause damage to plastic parts. When the system is started after a shutdown longer than approximately 3 months, it is recommended that the system be checked by your service contractor. Regarding the instructions of Wired Remote Control Switch or Wireless Remote Control Switch, read the operation manual attached to the control switch.
  • Page 9: Troubleshooting

    7. Troubleshooting...
  • Page 10 R410A...
  • Page 13 for Suspension Bolt Model 07~14 17~24...
  • Page 15 Refrigerant Gas Refrigerant Liquid Drain Pipe Pipe Connection Pipe Connection Connection field- Optional Optional Model 07~14 17~18 Optional 22~24 Flaring Dimension Perform the flaring work as shown below. ΦD Φa R410A R407C 6.35 9.1 9.0 13.0 9.53 13.2 12.7 16.2 16.6...
  • Page 16 Drain Pump(optional) Standard...
  • Page 18 Electrical Box Cover Air Outlet Air lnlet Remove the fixing screws for electrical box cover PCB2 PCB1 Cord Clamp 220V~ 60Hz 07~24...
  • Page 19 Use an ELB (Electric Leakage Breaker).If not Use an ELB (Electric Leakage Breaker).If not used ,it will cause an electric shock or a fire. used ,it will cause an electric shock or a fire. Run through the cables using conduit tube, Run through the cables using conduit tube, and Completely seal the end of conduit tube and Completely seal the end of conduit tube...
  • Page 20 Ex.) Set at No.5 Cycle Set by inserting Setting DSW5 Slotted screwdriver Position into the groove Set All Pins OFF Before shipment. DSW5 and RSW2 are set to "0". RSW2 Max.64 cycles are available to set when all the equipment to be connected are corresponding to Hi-NET.
  • Page 22 1018389 Qingdao Hisense Hitachi Air-conditioning Systems Co., Ltd. Add: 218, Qianwangang Road, Economic & Technical Development Zone, Qingdao, P.R. China http://www.hisense-vrf.com E-mail:export@hisensehitachi.com P00546Q 2018.03...