Start/Stop Button; Remove Items From Pocket And Check Work; Stopped Document In Track Conditions - Digital Check QUANTUM DS Series Installation And Operation Manual

Operating the unit
2. To continue running more items, remove the remaining items from the feeder
bay. Reinsert the items (and/or additional items) into the feeder bay. Press the
Start/Stop button, or use your application software interface to resume
document processing.

Start/Stop Button

The Start/Stop button initiates document processing. Use the Start/Stop button to:

Start or stop document flow.

Restart document flow after a track stop (center status light is amber).

Clear stopped items in the track. Hold down the Start/Stop button for three
seconds to move the stopped item(s) in the track to a pocket ("flush the track").

Remove Items from Pocket and Check Work

To prevent jams, you should remove items from the pocket when the pocket is nearly full.
Pocket capacity is up to 200 items, depending on thickness and condition. Verify that
endorsements are clearly printed, and that image quality is acceptable (if the application
allows image viewing.)

Stopped Document in Track Conditions

If an item stops in the track, or does not fully enter a pocket, it must be removed from the
track before documents can flow again.
Note: When this happens, you must check your application documentation for
information on clearing stopped items and perform the necessary recovery
steps.
The item may have stopped in the track due to one or more of the following:

Unacceptable size

Creases, folds, curls, or dog-ear corners

Rubber bands, paper clips, staples, or foreign objects

Check stubs or adding machine tapes

Torn or damaged paper

Missing or misaligned ink jet cartridge when endorsement is enabled
Start/Stop Button
2-8
82275345-003