Install The Applications - Hach LANGE TitraLab KF1000 Series User Manual

Startup
Parameter
Active
Stirring speed
Measured parameter
Delay
Injection autodetect
End point
Proportional band
Drift threshold
Maximum addition speed
Minimum titration duration Minimum time for the titration
Maximum titration duration Maximum time for the titration
Result 1 (R1) name
R1 maximum resolution
R1 hide
R1 limit check
R1 minimum
R1 maximum
R1 QC minimum
R1 QC maximum
R1 unit
R1 molar weight
R1 sample equivalent
R1 titrants equivalent

5.2 Install the applications

22
Table 8 KF titration parameters
Description
Specify if the method should be used during the analysis
Stirring speed during the titration
Parameter measured by the probe
Stirring time before the titration starts
Define if the calibration starts after the automatic detection of a
sample injection
Ordinate of the end point
Proportional band of the PID regulation
The drift value, below which the cell is considered to be dry
Maximum speed for titrant addition
Result name
Maximum number of decimals to show for the result
Specify if the result is shown or not shown on the display
Specify if the sample result is checked to be within the accepted
boundaries
Minimum accepted result value
Maximum accepted result value
Minimum accepted QC result value
Maximum accepted QC result value
Result unit
Molar weight of the analyte used to calculate the result
Number of exchanged equivalents of the sample
Number of exchanged equivalents of the titrant
Use the supplied USB key to install the applications. The instrument can install a
maximum of five applications. The installed applications are shown on the top line of the
display. If any errors occur during installation, refer to
1. Push Home to go to the main menu.
2. Connect the USB key to the USB port on the side of the instrument. The applications
on the USB key show on the display.
3. Push the arrow keys to highlight and select an application to install. Push the left or
right arrow key to select it. Do this step again to select additional applications to
install.
4. Push Import to install the selected applications.
5. Push OK to complete the installation. The installed applications show on the main
menu.
Note: To install more applications, push Home to go to the main menu, then remove the USB
key and reconnect it.
Basic mode Expert mode
x
x
x
x
x
x
x
x
x
x
x
x
x
x
Troubleshooting on page 35.
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x