Install The Sensor; Connect The Sensor - Hach LANGE TitraLab KF1000 Series User Manual

Installation

3.8 Install the sensor

3.8.1 Connect the sensor

12
Use a conical adapter to hold the sensor tightly in the sensor holder. Make sure the
conical adapter is installed correctly. This makes sure of a secure water-tight fitting in the
sensor holder and the tip of the sensor will be in the correct position in the beaker.
Connect the sensor to an available sensor port on the rear of the instrument. After the
sensor is connected, make sure that the sensor icon shows in the banner at the top of the
display. Refer to the illustrated steps that follow.