Install The Applications; Prepare The Instrument For Measurement - Hach TitraLab AT1102 User Manual

Startup

6.2 Install the applications

6.3 Prepare the instrument for measurement

30
Option Description
Options Sets the following options:
•
•
•
•
•
•
Note: When the instrument is set to on, the application parameters view is
always set to basic mode. Changes made to application data with the
instrument in expert mode are kept.
Security Change the password. Specify which of these options are password
protected:
•
•
•
•
•
•
•
•
3. Push Back.
Use the supplied USB key to install the applications. The instrument can install a
maximum of five applications for each syringe installed. For two syringes, the installed
applications shown on the top line of the display refer to syringe one and the installed
applications shown on the second line refer to syringe two.
If any errors occur during installation, refer to
1. Push Home to go to the main menu.
2. Connect the USB key to the USB port on the side of the instrument. The applications
on the USB key show on the display.
3. Push the arrow keys to highlight and select an application to install. Push the left or
right arrow key to select it. Do this step again to select additional applications to
install.
4. Push Import to install the selected applications.
5. Push OK to complete the installation. The installed applications show on the home
screen.
Note: To install more applications, push Home to go to the home screen, then remove the
USB key and reconnect it.
1. From the home screen, select Purge. All attached devices are listed.
2. Select All elements to purge all the attached devices, or select one device to purge.
Push Select. Air is removed from the device and filled with liquid from the bottle.
3. Push OK when the operation has completed.
4. Make sure that there are no air bubbles in the device. Do step
air bubbles.
Set the application parameters view to expert or basic mode
When the instrument is set to off, sets the syringe to empty into the
titrant bottle
Changes the temperature display unit
Prints the measurement and derivative curves if a printer is connected
Specify if a balance is connected
Specify if an external propeller stirrer is connected.
Settings (all items except Info)
Maintenance schedule and summary
Delete data log
Export data log
Electrode calibration
Titrant calibration
Sample volume calibration
Syringe verification test
Troubleshooting on page 49.
2 again if there are any