Install An External Propellor; Install Pc Software - Hach LANGE TitraLab KF1000 Series User Manual

3.11.2 Install an external propellor

3.11.3 Install PC software

Figure 5 Typical setup that can be used with the PC software
1 Balance for weighing the sample
2 Printer
3 Computer with PC software installed
1. Remove any bends in the end of the tube from the inlet port on the pump.
2. Push the tube into a tube holder slot so it is correctly attached.
3. Make sure that the end of the tube is near the bottom of the beaker.
4. Make sure that the tube from the outlet port of the pump is installed in an applicable
container.
5. Connect the pump to the external pump port on the rear of the instrument (refer to
Figure 2 on page 7).
This accessory (Item no. LZE143) is used as an alternative to the standard magnetic stir
bar, for more viscous samples.
1. Install the propellor into an available slot on the sensor holder.
2. Make sure that the end of the propellor is near the bottom of the beaker.
3. Connect the propeller to the external propeller port on the rear of the instrument (refer
to Figure 2 on page 7).
The optional PC software connects with the TitraLab
network. The software can be used to:
®
• Control a TitraLab
• Control a sample changer to start and stop analyses
• Control a balance for accurate sample weighing
• Show run-time data directly from the workstation
• Manage data stored locally or on a server (search, compare, delete, print, etc.)
• Export data to files for use in other software applications
Full product documentation and on-line help is available with the software.
Refer to Figure 5 for a typical PC setup that includes connections to a balance, printer,
®
TitraLab workstation and sample changer.
workstation to start and stop analyses
®
4 TitraLab workstation
5 Sample changer
Installation
®
workstation through an Ethernet
15