OPERATING PROCEDURES
n. Self-Closing Door Assembly
Position the freezer door onto the four studs on
the front of the freezing cylinder and push the
door into place. Install the four handscrews onto
the studs and tighten them equally in a crisscross
pattern to ensure that the door is secure. Do not
overtighten the handscrews.
Note: If the freezer door does not fit into place
easily, put the open end of the beater assembly in the
11 o'clock position.
o. Self-Closing Door Assembly
Position the torque arm by inserting it down into
6
the hole on the torque rotor, which protrudes from
the door. Verify proper installation by moving the
torque rotor back and forth to make sure it moves
freely.
Proceed to Step 18.
6-8
Figure 6-30
Figure 6-31
18. Install the front drip pan: Slide the long drip pan into
the hole in the front panel.
101692
19. Install the front drip tray and splash shield beneath
the door spout.
101693
20. Lay the air/mix feed tube (optional) in the bottom of
the mix hopper.
Model 428
Figure 6-32
Figure 6-33
Figure 6-34
Operating Procedures
101599
101581