OPERATING PROCEDURES
e. Self-Closing Door Assembly
Move the draw handle to the forward position to
allow installation of the ice buster.
f. Self-Closing Door Assembly
From the back side of the door, install the ice
buster through the door spout and into the slot
located just above the lower O-ring.
6
g. Self-Closing Door Assembly
Move the draw handle to the back position to lock
the ice buster in place.
6-6
Figure 6-21
Figure 6-22
h. Self-Closing Door Assembly
Turn the door right side up. Remove the draw
valve handle. Install it on the other side, through
the longer slot and into the draw valve hole.
i. Self-Closing Door Assembly
Insert the valve handle pin. Turn the pin and the
draw valve handle until the pin drops completely
into place.
Model 428
Figure 6-23
Figure 6-24
Figure 6-25
Operating Procedures