Taylor 428 Operator's Manual page 22

OPERATING PROCEDURES
WARNING! Use extreme caution when
handling the beater assembly. The scraper blades are
very sharp and may cause injury.
4. Before installing the beater assembly, inspect the
scraper blades.
Check the scraper blades for any signs of wear or
damage. If a scraper blade is nicked or worn, replace
both blades.
6
6-2
Figure 6-4
Figure 6-5
5. If the blades are in good condition, place the rear
11394
scraper blade over the rear holding pin (knife edge to
the outside). Holding the blade on the beater, turn it
over and install the front blade the same way.
Note: The hole on the scraper blade must fit securely
over the pin to prevent damage.
6. Holding the blades in position, insert the beater
assembly into the freezing cylinder and slide the
assembly into position over the driveshaft.
Turn the beater slightly to make sure that the beater
is properly seated. When in position, the beater will
not protrude beyond the front of the freezing cylinder.
7. Install the white plastic guide bearing on the short
end of the torque rotor. Slide the O-ring into the
groove on the long end of the torque rotor and
lubricate the O-ring. Do not lubricate the guide
bearing.
Model 428
Figure 6-6
Figure 6-7
Operating Procedures
30005_A
11182