Transport; Preparing For Installation; Removing / Fitting The Cylinder Casing; Checking The Signal Anode - STIEBEL ELTRON SBB 301 WP Operation And Installation

.CZ`<<`.HC
T ¼ | ê Ö Ï
8.2

Transport

Material losses
We recommend removing the cylinder casing for trans-
portation to the installation location to prevent it from
becoming dirty or damaged.
SBB 501 WP SOL
f Both side insulation sections can be removed for transporta-
tion in tight spaces. To do this, remove the cylinder casing.
f Use the fixing straps to refit the thermal insulation sections
after transportation.
1
1 Side thermal insulation section
f Ensure that the closures are in the joint between a side
thermal insulation section and the thermal insulation of the
cylinder.
Ä ’ Z éÑ qT ZH<
ê |ùù| ê
1
9.

Preparing for installation

9.1 Removing / fitting the cylinder casing
Note
Open or remove the cylinder casing before fitting the DHW
circulation and indirect coil lines.
Fit the cylinder casing before fitting a flanged immersion
heater.
The plinth trim should be fitted after the tightness check.
9.2

Checking the signal anode

Material losses
The appliance must not be operated without a consump-
tion indicator or with a damaged one, otherwise water
will leak out once the anode is depleted.
9.3

Heating installation

f Flush the indirect coils with water before connecting the
heating water pipes.
SBB 401 WP SOL | SBB 501 WP SOL without solar installation
f You may connect both indirect coils to the "heat pump heat-
ing return" and "solar flow" (see chapter "Specification /
Dimensions and connections").
9.4 Fitting the water connection and the safety
assembly
Note
Carry out all water connection and installation work in
accordance with regulations.
f Flush the line thoroughly.
f Connect the DHW outlet and the cold water inlet lines with
the safety assembly. Bear in mind that, depending on the
static pressure, you may also need a pressure reducing valve.
꼐¼ùé¼ù ›