Table of Contents
Advertisement
iNSTallaTiON
installation
10.2 Transport and handling
Material losses
!
Store and transport the appliance at temperatures be-
tween -20 °C and +60 °C.
Note
Two people are required when installing the adjustable
feet and transporting the appliance.
f Undo the 3 screws on the non-returnable pallet.
f
Material losses
!
Never roll the appliance over the edge of the pallet.
Installing supplied carrying straps and adjustable feet
1 Carrying strap
2 Washer
3 Adjustable foot
4 Pipe
5 Threaded hole
www.stiebel-eltron.com
f Slide a pipe over one carrying strap.
f
f Fold over the end of the carrying straps with the two holes
f
and insert an adjustable foot with washers into the carrying
strap, as shown in the figure.
f Tilt the appliance.
f
f Screw the adjustable foot with the carrying strap into one
f
of the threaded holes (shown in the figure) in the appliance
base.
f Fit the second carrying strap likewise.
f
f Screw an adjustable foot without a carrying strap into the
f
threaded hole in the appliance base.
1 Carrying straps
f Lift the appliance off the pallet by the carrying straps.
f
f After transportation, tuck the lower carrying straps under the
f
appliance. You can also cut off the upper and lower carrying
straps.
11. Installation
1
11.1 Positioning the appliance
f When positioning the appliance, observe minimum clearanc-
f
2
es (see chapter "Preparations / Installation site").
f Use the adjustable feet to compensate for any unevenness in
f
the floor.
3
4
5
1
1
Material losses
!
Always carry the appliance by the carrying straps.
Never transport the appliance using a hoist.
During transportation, never subject the pipe connectors
to any strain.
Protect the appliance against heavy impact during trans-
port.
HSBB 180 Plus (GB)|HSBB 180 S Plus (GB)|
1
7
Advertisement
Table of Contents
