Safety Instructions - Japa 485 User Manual

japa
485

1.7 Safety instructions

These safety instructions are general in nature. When handling the machine, you must take into
account all other relevant instructions concerning health and safety, road traffic regulations regarding
transportation, as well as the provisions of the general legislation. Observing these instructions helps to
prevent accidents.
The machine may only be used by persons who have familiarised themselves with the manual and the
operation of the machine. The operator must not be under the influence of alcohol or narcotic
substances. The requirements placed on the operator, as well as the minimum age of 18 required to
operate the machine, must be taken into account.
Study the machine's safety and installation instructions carefully, along with the operation and control
functions, before installing and operating the machine.
General provisions:

The machine must be used solely for making firewood.

Only one person may operate the machine at a time.

Ensure that no unauthorised persons are in the working area. The danger zone is 10 m.

Always check the condition of any possible power cables.

Always use approved eye and ear protection.

Clean and maintain the machine on a regular basis.

Always stop the machine before maintenance and, if the machine is tractor-driven (TR),
disconnect the cardan shaft. If the machine features an electrical drive (E), disconnect the
power cable.

Check the operation of the safety equipment. Do not use the machine if part of the mechanism
is not functioning properly.

The machine may only be transported in the transport position. This is the responsibility of the
driver.

If the firewood processor is to be transported on the road, the widest parts of the machine must
be marked with alternating red and yellow stripes. The markings can be implemented with flags
or tape. The widest parts of the machine must also be equipped with forward-facing white and
backward-facing red reflectors with either EC or E type approval. Attention must be paid to
sufficient front axle weight.

The machine can only be used to process clean wood (no nails, screws, sand, etc.)
Working area:

Select a level and solid working area.

Keep the area clean and free of obstructions.

Ensure that the ground or floor is not slippery near the machine.

Do not use the machine indoors, as the dust may enter your airways or cause a fire hazard.

Only use the machine with sufficient lighting: daylight is recommended.

Place the machine in the working position. Always check the safety devices before starting the
machine.
During operation:

Take extreme care when cutting knotty or bent wood.

When sawing incorrectly, the log may spin, causing injury or machine damage.

Careless sawing or splitting may cause unexpected hazards.

Ensure that the PTO shaft is undamaged and attach the shaft guard chain to the machine.

Avoid unnecessary lifting by using a suitable log rack.

Do not lift logs directly onto the input table with a loader.
DO NOT LEAVE A RUNNING MACHINE UNSUPERVISED!
Translation 7
User manual
485 1.0-2014