Starter - Husqvarna 131RB Workshop Manual

8.3 Starter

8.3.1 To disassemble the starter on 967 84 33-xx
WARNING: Use protective glasses to prevent
injury to the eyes if the recoil spring ejects.
1. Pull up the knob and remove the shaft.
2. Remove the screw (A), the spark plug cap (B), the
spark plug cable (C) and the spark plug. Remove
the screw (D) from the cylinder cover (E).
A
E
3. Remove the screws (F) and the cylinder cover.
Remove the screws (G). Remove the screws (H).
Remove the engine from the support plate on the
harness frame.
F
G
24 - Repair instructions
B
D
C
H
4. Remove the starter assembly (I) and the gasket (J).
I J
5. Pull out the starter rope approximately 30 cm. Slow
the starter pulley with your thumb. Put the starter
rope in the groove in the starter pulley. Let the
starter pulley rotate rearward until the spring tension
stops.
WARNING: The recoil spring can cause
injury to your thumb when the starter pulley
rotates in reverse.
627 - 002 - 23.04.2018