Muffler; Harness Frame - Husqvarna 131RB Workshop Manual

8.15 Muffler

8.15.1 To disassemble the muffler
1. Remove the 2 screws (A), the washers (B) and the
screw (F).
2. Remove the muffler cover (C), the muffler (D) and
the heat shield (E).
3. Remove the screw (H) and the protective plate (G).
C
B
A
F
8.15.2 To clean and examine the muffler
WARNING: Risk of burn injury or fire. Mufflers
with catalytic converters become very hot during
operation.
WARNING: Risk of fire. The exhaust gases are
hot and can contain sparks.
1. Clean all parts. Clean the spark arrester screen with
a wire brush.
2. Examine the muffler for wear and damage. Replace
the muffler if it is damaged.
3. Examine the spark arrester screen. Replace the
spark arrester screen if it is damaged.
4. Examine the remaining parts. Replace worn or
damaged parts with new ones.
5. Make sure that the muffler is correctly attached to
the product.
8.15.3 To assemble the muffler
1. Attach the protective plate (G) with the screw (H).
2. Hold the heat shield (E) in position and attach the
muffler (D) and the muffler cover (C).
62 - Repair instructions
H
E
D
G
3. Attach the screw (F), the washers (B) and the 2
screws (A).
C
B
A
F

8.16 Harness frame

8.16.1 To disassemble the harness frame
1. Pull up the knob and remove the shaft.
2. Remove the fuel hose (only on the model 967 84 33-
xx).
H
E
D
G
627 - 002 - 23.04.2018