Air Filter - Husqvarna 131RB Workshop Manual

4. Put the spring (C) on the throttle lock (D) and put it
in the correct position on the handle half. Put the
throttle trigger (A) on the handle, make sure the end
of the spring (B) is in the correct position in the
handle. Make sure that the black cable (G), the red
cable (F), the stop switch (H) and the throttle wire
(E) are attached as shown in the illustration.
F
G
E
5. Put the shaft in the left handle half and attach the
right half with the screws and the nuts. Make sure to
use the correct torque, see
model 967 84 33-xx on page 14 .
.

8.6 Air filter

8.6.1 To disassemble the air filter on 967 84 33-xx
1. Turn the engine around its axle to get access to the
air filter.
2. Remove the screws (A) that hold the air filter cover
(B).
3. Remove the air filter (C).
4. Remove the air filter net (D).
36 - Repair instructions
H
C
B
D
A
Servicing data for the
5. Remove the air filter holder (E), if it is dirty or
damaged.
E
D
C
B
A
8.6.2 To disassemble the air filter on 967 84 32-xx
1. Turn the engine around its axle to get access to the
air filter.
2. Turn the knob (A) to remove the air filter cover (B).
3. Remove the filter holder (C).
4. Remove the air filter (D).
5. Remove the air filter holder (E), if it is dirty or
damaged.
E
D
C
B
A
627 - 002 - 23.04.2018