4. Put the liner (E) straight and align the flexible shaft
(D) with the angular hole (G) on the side of the
clutch drum.
I
H
E
G
F
5. Install the liner (E) into the clutch housing (F). Make
sure that the hole on the end of the liner points
directly up.
6. When the hole (H) moves directly below the stopper
(I), you can hear a click which means the stopper
locks the liner.
1. If you cannot lock the liner (E) into position, pull
it out.
2. Turn the flexible shaft a small distance and try to
lock the liner (E) again.
7. After you lock the liner (E) into position, pull on the
liner to make sure the stopper works correctly.
3.2 Function test on the model 967 84 33-xx
3.2.1 To examine before start
1. Examine the product for missing, damaged, loose or
worn parts.
2. Examine the nuts, screws and bolts.
3. Examine the blades.
4. Examine the locknut. Make sure that the locknut has
a minimum locking force of 1.5 Nm (1,1 ft lb). Torque
the locknut to 35-50 Nm (26-36 ft lb).
5. Examine the air filter.
6. Examine the throttle trigger lockout and the throttle
control.
7. Examine the stop switch.
8. Examine the product for fuel leaks.
3.2.2 To start a cold engine
1. Set the stop switch to the start position.
2. Push the start throttle button.