Husqvarna 131RB Workshop Manual page 28

3. Put the pulley on the starter pulley and attach the
screw.
4. Pull the starter rope through the starter rope handle.
5. Make a small knot on the starter rope and pull the
knot into the handle.
6. Tighten the recoil spring. Pull out the starter rope
fully and slow the starter pulley with your thumb. Lift
the starter rope up out of the groove on the starter
pulley. Then turn the starter pulley counterclockwise
4 revolutions. Pull out the starter rope fully and turn
the starter pulley a minimum of a half revolution
more.
28 - Repair instructions
7. Put the gasket (K) on the crankcase and attach the
screws (H) to the starter housing (J) and crankcase.
Attach screws (G) to the support plate and the
bracket (I). Attach the nuts (L) to the screws (G) and
tighten. Put the cylinder cover in the correct position
and attach the screws (F) to the starter housing and
cylinder cover. Tighten the screws to the correct
Servicing data for the model 967 84
torque. Refer to
32-xx on page 16 .
K
L
G
8. Attach the screw (D) to the cylinder cover (E). Attach
the spark plug cable (C). Attach the spark plug cap
(B) and the screw (A). Tighten all screws to the
correct torque. Refer to
967 84 32-xx on page 16
A
E
8.3.7 To replace the drive
1. Remove the starter assembly as given in
disassemble the starter on 967 84 33-xx on page 24
To disassemble the starter on 967 84 32-xx on
or
page 25 .
2. Use a piston stop to lock the axle.
3. Loosen the nut (A). Remove the drive and the
spacer in the drive disc.
J
F
H
I
Servicing data for the model
B
D
C
To
627 - 002 - 23.04.2018