Bevel Gear - Husqvarna 131RB Workshop Manual

4. Pull up the knob and attach the shaft.
627 - 002 - 23.04.2018

8.12 Bevel gear

8.12.1 To disassemble the bevel gear
1. Remove the trimmer head (A). Remove the support
flange (Y). Put a rod through the hole (B) to lock the
axle. Remove the protective plate (C). Remove the
screw (D), the screws (E) and the bracket (F).
Remove the screw (G) and the bracket (H). Remove
the screw (I) and pull out the gear housing (J).
E
F
H
G
2. Remove the bushing (K). Remove the snap ring (L)
with pliers. Remove the snap ring (M) with pliers.
Remove the grease plug (N).
N
M
D
J
C
I
Y
B
A
K
L
Repair instructions - 49