To Clean And Examine The Product Parts; Starter - Husqvarna 331R Workshop Manual

7. Centrifugal clutch
8. Flywheel
9. Cylinder and piston
10. Crankcase and crankshaft
11. Fuel tank
12. Handle
13. Gearbox

7.2 To clean and examine the product parts

• Clean and examine all parts fully. You find more
instructions in the chapter for each part if special
tools or procedures are necessary.
• Replace damaged or defective parts.
• Always use original spare parts.
12 - Repair instructions

7.3 Starter

7.3.1 To disassemble the starter
WARNING: Use protective glasses to prevent
injury to the eyes if the recoil spring ejects.
1. Loosen the screws and remove the shaft assembly.
2. Remove the 4 screws and pull out the starter unit
and gasket.
1296 - 001 - 27.09.2019