Function Test On The Model 967 84 32-Xx - Husqvarna 131RB Workshop Manual

3.2.4 To stop
• Push the stop switch to stop the engine.

3.3 Function test on the model 967 84 32-xx

3.3.1 To examine before start
1. Examine the product for missing, damaged, loose or
worn parts.
2. Examine the nuts, screws and bolts.
3. Examine the blades.
4. Examine the locknut. Make sure that the locknut has
a minimum locking force of 1.5 Nm (1,1 ft lb). Torque
the locknut to 35-50 Nm (26-36 ft lb).
5. Examine the air filter.
6. Examine the throttle trigger lockout and the throttle
control.
7. Examine the stop switch.
8. Examine the product for fuel leaks.
3.3.2 To start a cold engine
1. Set the stop switch to the start position.
2. Push the start throttle button.
3. Press the air purge 10 times.
8 - Prepare and do servicing on the
product
4. Set the choke control in the choke position.
5. Hold the body of the product to the ground with the
left hand. Pull out the cord slowly with your right
hand until you feel some resistance. Pull the cord
quickly with force. Keep doing it until you hear the
engine start.
WARNING: Use the starter rope handle. Do
not twist the starter rope around your hand.
CAUTION: Do not pull out all the starter
rope. Do not let go of the starter rope handle
when the cord is fully extended.
6. Set the choke control to the run position, then pull
the start rope until the engine starts.
7. Pull the throttle trigger lightly and run at low speed
for 60 seconds.
WARNING: Do not touch the cover. It can
burn your skin and cause electrical shock if
the spark plug cap is damaged. Do not use
a product with damaged spark plug cap.
627 - 002 - 23.04.2018