Husqvarna 967187001 Workshop Manual page 39

Repair Work
9
Loosen the articulated shaft's screw from below.
10
Tap out the bearings and the sleeve with a
mandrel. The lower bearing is tapped out from
above. The upper bearing is tapped out from
below.
11
Press new bearings in by using a bearing
assembly kit.
12
Assemble the articulated steering in the reverse
order as set out for removal. If the pendulum shaft
needs replacement, refer to "7.7 Removing the
Pendulum Shaft".
After mounting, the cable tension should be
checked. Check that the controls and cables are
properly adjusted.
39
English –