Removing/Fitting The Steering Shaft - Husqvarna 967187001 Workshop Manual

7.2 Removing/Fitting the Steering Shaft

1
1
Loosen the rear fastening of the steering cables (1).
2
Remove the frame cover by loosening the screws.
3 pcs screws:
3
Remove the steering wheel and steering column
by punching the pin out with a mandrel, lift the
steering wheel and steering column upwards.
4
Unscrew the screw (13) in the lower edge of the
steering column.
(The steering column can be held using the
mandrel)
5
Pull the steering wheel shaft (11) upwards and
move the lower part of the shaft backwards to pull
off the steering chain (12).
6
Move the upper bearing (10) upwards until it
moves freely from the steering wheel shaft (11).
If the bearing needs replacement, the bushing (9)
must be tapped out of the bearing.
7
Remove the steering wheel shaft (11) in a
downwards movement.
8
To assemble the steering shaft, follow the
instructions in the reverse order.
Repair Work
9
10
11
12
13
English –
35