Configuring The Application Card - Aastra 470 Installation Manual

Configuring the application card

Configure the applications card by executing the configuration processes in
the following order:
configure the OIP and TWP applications. To secure the configuration data,
create a backup in the end.
Settings under Basic configuration
The general settings are described below.
Basic configuration
Parameter
Company name
Name sequence (as recorded in
the communication server).
Use DNS server name in LAN (if
available)
IP address
Communication servers in
subnet
Old password
New password
Windows work group settings
CTI server configuration portals
Applications Card CPU2
syd-0421/1.2 – R2.1 – 07.2012
Basic configuration,
Explanation
Enter the customer's company or organisation name here.
Define the order of first name and surname here. The setting is applied to all
applications of the applications card. Select the same order as defined in the
communication server's phone books.
Note:
Perform this setting at the beginning of the configuration process and, if
possible, do not modify the setting in a fully configured system.
Choose this option if a DNS server is set on your IP network.
Communication server IP address
If the wrong IP address is entered, the setup wizard has probably detected
other communication servers on your subnet. You can see all the IP addresses
of detected communication servers under
Choose the IP address of the right communication server and click the button
<<, to confirm it.
List of the IP addresses of all detected communications servers on the subnet.
To use any of the IP addresses, click the
The application card current password used for the Windows operating
system as well as on the installed OIP and TWP applications.
The application card new password is automatically used for the Windows
operating system on the application card as well as on the installed OIP and
TWP applications. To change the password may takes several minutes.
These settings are only relevant if the application card is to be integrated into
a Windows work group.
Note:
The application card can be used in a domain environment, but should not
be a member of a domain.
In this section, you will find a link to the OIP toolbox and a link to the TWP
configuration page. Log on using the username
application card password.
Configuring the application card
IP Network and Licenses. Then
Found communication
<< button.
cpu2-emmc
server.
and the
13