Replacing An Application Card - Aastra 470 Installation Manual

Replacing an application card

To replace an application card without complications, follow the instructions
below.
Removing the application card
To remove an application card, proceed as follows:
1. Switch off the application card, by pressing the On/Off pushbutton on the front
side of the card.
2. Switch off the communication server and remove the application card.
3. Switch on the communication server.
4. From your administration PC, open your communication server's WebAdmin
and log on.
5. Navigate up to the card window
and click the Delete
Installing a new application card
To install a new application card, proceed as follows:
1. Remove the TWP dongle from the existing application card and fit it to the new
application card.
2. Install the new application card and start it up following the instructions
"Installing the application card", page
Applications Card CPU2
syd-0421/1.2 – R2.1 – 07.2012
(Configuration
button at the end of the Slot 2 line.
10.
Replacing an application card
/ System / Cards and Modules)
21