Dräger Polytron 7000 Instructions For Use Manual page 65

– Test fault
— This function simulates the fault alarm state for testing purposes.
Select the menu items » Settings «, » Instrument «, » Alarm « and » Test fault
alarm « in this order, pressing the »
— The function » Test fault status « is opened.
Select » Enable « or » Disable « and press the »
— When the function is enabled, the relay and the interfaces are set to the fault
alarm state.
Passwords
This group contains the setting functions for the passwords.
– Password Calibration
— This function is used to change the password for the menu » Calibration «.
Select the menu items » Settings «, » Instrument «, » Passwords « and
» Password Cal. « in this order, pressing the »
Select the line for password input and press the »
Use the » « and »
M
the » « key to confirm the setting.
OK
Press the » « key to confirm the complete password.
OK
– Password Settings
— This function is used to change the password for the menu » Settings «.
Select the menu items » Settings «, » Instrument «, » Passwords « and
» Password Cfg. « in this order, pressing the »
Select the line for password input and press the »
Use the » « and »
M
the » « key to confirm the setting.
OK
Press the » « key to confirm the complete password.
OK
Date and time
— This function is used to set the date and / or time.
Select the menu items « Settings «, « Instrument « and « Date and time « in this or-
der, pressing the » « key after each selection.
OK
Select the desired input line (Date or Time) and press the »
edit mode.
Use the » « and »
M
the setting.
« key after each selection.
OK
OK
« key after each selection.
OK
OK
« keys to set each position of the password and press
« key after each selection.
OK
OK
« keys to set each position of the password and press
« keys to set the value and press the »
« key to activate.
« key to switch to edit mode.
« key to switch to edit mode.
« key to switch to
OK
« key to confirm
OK
The menu » Settings «
65