Submenu " Datalogger - Dräger Polytron 7000 Instructions For Use Manual

The menu » Settings «
Submenu » Datalogger «
The submenu » Datalogger « permits various settings to be made for the Datalogger
and the Eventlogger.
These functions are available only if the Polytron 7000 transmitter is equipped with
the Data Dongle 83 17 618, see page 29.
The contents of the Datalogger or Eventlogger can be evaluated only with the
PC software GasVision (Version 5.5 or higher). The contents of the Datalogger for
the previous 15 minutes can be viewed with the menu sequence » Information «,
» Datalogger « and » Show graph «, page 55.
Datalogger:
The Datalogger saves the measured values in accordance with the configuration
set under » Set Datalogger «. The Datalogger can save at least 3000 measured val-
ues. If the data is saved at intervals of one minute, this is sufficient for a monitoring
period of 50 hours. The monitoring period can be extended considerably by using
the setting » Trigger « (page 79).
Eventlogger:
The Eventlogger saves unit and sensor events (such as: A1 threshold value
exceeded; flow fault in pump). The Eventlogger can save a maximum of 100 events
Logger on/off
— This function is used to enable or disable the Data- or Eventlogger.
Select the menu items » Settings «, » Datalogger « and » Datalgr. On/off « in this
order, pressing the »
OK
Select » Enable « or » Disable « and press the »
Datalogger setting
This group contains the setting functions for the Datalogger.
– Sample time
— This function can be used to set the sample time for the Datalogger.
Select the menu items » Settings «, » Datalogger «, » Set Datalogger « and
» Sample time « in this order, pressing the »
Select the desired sample time from the list and press the »
activate it (» «).
78
« key after each selection.
« key to activate.
OK
« key after each selection.
OK
« key to
OK