Table of Contents
Advertisement
Operation Continued
Tips
• Mow - Mow the lawn to its normal cut height.
• Water - For the best performance and maximum tine penetration the lawn should be thoroughly watered
the day before aeration.
• Inspect - Check the lawn before beginning work. Remove all rocks, wire, string, or other objects that can
present a hazard during work prior to starting
• Identify - Mark all fixed objects to be avoided during work, such as sprinkler heads, water valves, buried
cables, or clothes line anchors, etc.
• Slopes - Do not operate the aerator on steep slopes (any slope exceeding 15°). Use extreme caution
when operating on any sloped surface. For lesser sloped areas operate the unit, traversing up and down at
a 45° angle to the slope rather than straight across. Extended operation on steep slopes can cause engine
damage.
Maintenance
Item numbers in parentheses can be referenced in the Parts Illustration and Parts List on pages 7-9.
Periodic Maintenance
Periodic maintenance should be performed at the following intervals:
Maintenance Operation*
Inspect for loose, worn, or
damaged parts
Thoroughly clean all debris
from unit and tines
Grease wheel bearings and
tine hubs
*Engine must be level when checking or filling oil
Individual Tine Replacement
1. Remove the bolt and nut (Items 46 and 43, respectively).
2. Replace the tine and then secure it in place with hardware previously removed.
Note: Tines are a normal wear item and should be inspected regularly for signs of wear or damage.
Troubleshooting
Problem
Abnormal Vibration
Part No. 100384
Every Use (or daily)
•
Table 2: Maintenance
Possible Cause
Damaged or missing tines. Loose
bolts.
Table 3: Troubleshooting
Every 10 hrs
•
Stop work immediately. Replace any
damaged or missing tines. Tighten all
loose nuts and bolts.
6
Every 50 hrs
•
Solution
100384_A_LO
Advertisement
Table of Contents
