Protecting Ctp2000 Modules And Slots - Juniper CTP2000 Series Hardware Manual

Protecting CTP2000 Modules and Slots

To prevent damage from electrostatic discharge, wear an antistatic wrist strap, and connect it to one of
the jacks when handling components. The CTP2056 has an ESD (electrostatic discharge) grounding jack
located in the rear lower-left corner of the chassis near the power switch. There are no ESD jacks on the
other CTP2000 platforms, so you must use another grounding device.
To protect the modules, components, and slots when installing components, observe the following guidelines:
CAUTION:
one of the device's ESD grounding jacks or to another grounding device. This action
helps to protect the module from damage by electrostatic discharge.
CAUTION:
leads, or solder connections.
CAUTION:
ejectors, remove it from the chassis and confirm that the slot is designed to hold the
module. Also, be sure that you have aligned the left and right edges in the correct
matching module guides.
CAUTION:
device from dust or other foreign substances and to ensure proper device cooling.
CAUTION:
an antistatic bag.
RELATED DOCUMENTATION
Safety Guidelines and Warnings for Installing CTP Modules | 74
Required Tools and Safety Items for Installing CTP Modules | 95
When handling components, use an antistatic wrist strap connected to
Always handle a module by its edges. Do not touch the components, pins,
If you meet strong resistance when attempting to seat a module using the
Be sure to cover every empty slot with a blank filler panel to protect the
Do not discard the antistatic bag. When a module is not in use, store it in
94