CHAPTER 12
Installing Modules
CTP150 Modules Slot and Port Numbering
Related
Documentation
Protecting CTP Modules and Slots
Copyright © 2015, Juniper Networks, Inc.
The CTP150 device has removable interface modules from the front, but no removable
fan trays.
In CTP150 devices, slot numbering is from left to right, 0 to 1. Any single module must be
installed in slot 0, and any single clock connection must come from the port in slot 0.
CTP150 port numbering on the front panel for the serial interface module is bottom left
0, top left 1, bottom right 2, and top right 3.
Port numbering for the T1/E1 interface module is 0, 1, 2, and 3, from right to left with a
clock port at the far right.
Protecting CTP Modules and Slots on page 53
Installing a CTP Interface Module, Processor Module, or Clock Module on page 55
To prevent damage from electrostatic discharge, wear an antistatic wrist strap, and
ensure proper grounding when handling components.
To protect the modules, components, and slots when installing components, observe
the following guidelines:
53